In domestic has been eliminated. Specific surface area test unified the multi-point BET method at home and abroad, specific surface area measurement standards are developed at home and abroad is based on BET test method, please see our national standard (GB/T 19587-2004) - gas adsorption BET principle of solid material specific surface area measurement methods. Specific surface area testing is actually the more time-consuming jobs, as the adsorption capacity of sample is different, some sample testing may need to spend the whole dayTime, if the test process is not fully automated, the tester can not leave at any time, and should be highly focused, observe the dashboard, control the knob, a little careless will lead to the failure of the test process, which will waste a lot of valuable time of the tester.
F - Sorb 2400 specific surface tester is really able to BET method detection instruments (both direct comparison method), the more important F - Sorb 2400 specific surface tester is by far the only specific surface area of the fully automated intelligent testing equipment, the test results with the international high consistency, the stability is very good also, at the same time reduce the human error, improve accuracy test results.Activated carbon air adsorption
As one of the means of harmless waste treatment, incineration method can quickly realize the reduction of waste, harmless and recycling, so it has been more and more widely used in China.
In the process of waste incineration, toxic organic compounds such as dioxins are inevitably produced, which causes environmental pollution problems.activated carbon pellet manufacturer
Activated carbon powder injection combined with bag dust collector (ACI+ BF) is an effective and widely used method to control dioxin emission from incinerator flue gas.
In order to provide reference and theoretical basis for the preparation and selection of activated carbon for the adsorption of dioxins, this paper carried out a study on the combined technology of activated carbon injection and double bag dust collector, the characteristics of activated carbon adsorption for dioxins and the influencing factors of activated carbon adsorption for dioxins.The adsorption and desorption isotherms of 13 kinds of commercial activated carbon were determined by low temperature nitrogen adsorption method, and the physical structures of activated carbon were calculated according to BET, T-Plot, BJH and DFT theory, and the iodine value and methylene blue value of 4 kinds of activated carbon were detected.
The physical structure characteristics of activated carbon were analyzed in detail to prepare for the subsequent experiment.
Using small activated carbon fixed bed adsorption gas phase dioxin test bench, a typical activated carbon adsorption dioxin factors affecting the experimental study, discusses the types of dioxin adsorption activated carbon and activated carbon fixed bed adsorption gas phase characteristics of dioxins, and discusses the adsorption temperature and adsorption time of activated carbon adsorption of dioxins.The results showed that the specific surface area and micropore volume of activated carbon had weak correlation with the adsorption efficiency of dioxins.
The mesopore volume of activated carbon is an important factor to determine the adsorption capacity of dioxins. The surface area of the pore size between 2 nm and 20nm plays a key role in the adsorption of dioxins.The higher the adsorption temperature, the lower the adsorption efficiency of activated carbon.The longer the adsorption time, the lower the adsorption efficiency of activated carbon.There is no selective adsorption of gaseous dioxins in activated carbon fixed bed.chinactivecarbon.com