Air velocity of empty tower :U= 1.0m /s.OriginalIts adsorption performance mainly depends on several main material parameters and process parameters on it [8. Material parameters including carbon adsorption porosity, thickness of honeycomb structure and the content of carbon; process parameters including fluid flow rate and concentration of the adsorption properties of adsorption, can adsorption depends on the carbon structure and adsorption properties of features such as molecular weight). The curve is one of the main performance characterization of adsorption, adsorption is the adsorbate concentration ratio before and after the change over time of a function [9 '. This ratio is 0.95, the amount of adsorption properties of adsorption is called penetration capacity. Penetration capacity depending on the fluid flow rate, the concentration of the adsorbate and honeycomb carbon component content
https://www.dxdcarbon.com/
Factors such as [10. For honeycomb activated carbon, the wall thickness is a very important parameter, by changing the wall thickness to improve its adsorption efficiency. Under the same porosity, thickness increases, the honeycomb carbon content per unit volume also will increase, which can improve the adsorption capacity. This is because the wall thickness increases, the fluid channel in the cellular cross-sectional area reduced, so the real surface or volume flow rate will increase. At the same time, the contact between adsorbate and carbon efficiency will, there is a balance between the two. Under the given conditions, the balance will determine adsorption increase or decrease. If the adsorbate at higher the diffusion rate diffuses to the inside of the honeycomb wall, and the empty adsorption site can be continuously adsorbed, so the thick-walled honeycomb should have better adsorption efficiency and adsorption capacity"Determination of air velocity and cross-sectional area of empty towerThe empty tower gas velocity is the velocity of gas passing through the entire cross section of the adsorber.The selection of air velocity not only directly determines the size and pressure drop of the adsorber, but also affects the adsorption efficiency.The experimental results show that the surface structure of the activated carbon material modified by FeSO changes: the specific surface area decreases, the surface oxygen content increases, the plane of the random layer graphite carbon net is destroyed to a certain extent, and the ammonia absorption capacity and benzene absorption performance of the sample are greatly enhanced.He ChunHong et al. [reported the research progress of supporting activated carbon materials in the removal of SO; the removal ability of SO was significantly enhanced after supporting Co, Ni, Mg, and V compounds, which was due to the formation of Co(OH)2, Ni(OH)2, Mg (OH)2, and V,0 microcrystals on the surface of activated carbon after supporting, which enhanced the desulfurization activity of activated carbon.wood based activated carbon manufacturer