If the gas speed is very small, the size of the adsorber is large and uneconomical.
If the gas velocity is too large, the pressure drop will increase and the adsorption efficiency will be affected.The optimum gas velocity was determined by experiment.
The adsorption design can not pursue too high adsorption efficiency, the empty tower speed value is reduced, it will make the adsorption bed volume, the amount of adsorbent and equipment cost increased greatly;On the contrary, it is not appropriate to take too large empty tower gas speed. Although the equipment cost is low, the adsorption efficiency drops a lot, and the pressure drop of the system will rise rapidly with the increase of the empty tower speed, resulting in excessive power consumption. Therefore, due to the selection of the appropriate air speed of the empty tower, the most suitable air speed of the empty tower is 0.8~1.2m/s"21, according to the empirical conclusion, this design determinesactivated charcoal pellets wholesale
conditions:Treatment air volume :Q=20000 m'h, design temperature is 35° C, pressure is 1.01325×103Pa  Since the proportion of air in exhaust gas is far greater than that of pollutants, the properties of exhaust gas can be approximately viewed as the thermophysical properties of dry air. Please refer to Appendix 9 of Principles of Chemistry to obtain the following data:Properties of air mixture:Fluid density P;=1.147kg/ m', viscosity u,= 1.94×10-5 Pa.S, specific heat capacity C,=1.005kJ/(kg."C)Electrochemical modification is to change the electrical and chemical properties of activated carbon surface by using micro electric field, so as to improve the adsorption selectivity and performance.It does not need to add chemical agents, does not need to heat, does not cause pollution to the environment, low energy consumption, only a few hundred millivolts, easy to operate.The results show that the adsorption equilibrium of activated carbon is dependent on the electric potential: the adsorption amount of activated carbon increases with the increase of the potential, and the adsorption speed is accelerated;Arpolarity polarization is beneficial to the adsorption of chloroform by activated carbon, while cathodic polarization inhibits the adsorption of chloroform by activated carbon 3-341]. Activated carbon heteroatom carrier and compound modificationActivated carbon has very high stability and good activity, these two basic properties become the activated carbon as a catalyst or catalyst carrier conditions.By introducing certain heteroatoms and compounds on the surface of activated carbon by liquid phase deposition, the adsorption performance of activated carbon can be increased by using the binding effect between these substances and adsorbents.compounds, which has the advantages of increasing the reaction rate and increasing the adsorption capacity.Yang Quanhong et al. 'Using FESO;Activated carbon material was modified.https://www.wyactivatedcarbon.com/