Because of its rich pore structure, huge specific surface area and good machinability, activated carbon has become the most studied and widely used adsorbent material in compound filter additives. This paper mainly discusses the activated carbon pore structure on the influence of the filtration efficiency of flue gas particle phase, for the application of active carbon composite filter in the Chinese style cigarette and cigarette * reduce harm reducing tar "work provide basic data and technical support, as well as the preparation with specific pore structure and properties of activated carbon and choose the smoke cigarette manufacturing using activated carbon has certain guiding significance.So it is widely used in the world sewage and waste gas treatment, air purification, recovery of rare metals and solvents and other environmental protection and resource recovery and other fields.Activated carbon is divided into granular activated carbon, powder activated carbon and activated carbon fiber, but because the powder activated carbon has secondary pollution and cannot be regenerated and activated, it is limited to use GAC-granular activated carbon (granular activated carbon)85%~90% of GAC is used for water treatment and gas adsorption treatment, and its particle size is 500~ 5000U m. The pore structure of GAC is generally a tridisperse pore distribution, which has been obtained according to the International Society of Pure and Applied Chemistry(IUPAC) Classification Aperture >Large pores at 50nm, intermediate pores at 2.0~50nm and ltWithout adding additives to the sludge, the concentration of sulfuric acid and zinc chloride is 4 mol·L' and the volume ratio is 2:1. The activated carbon prepared has the maximum iodine adsorption value of 549.6 mg·g 'and the yield of 51.3%, which is the better carbon sample prepared by pure sludge and is recorded as SAC.(3) Adding 8% peanut shell, the iodine value of activated carbon of sludge reached 789.6mg · g', which was recorded as PACIn order to verify the accuracy of the simulation calculation, two 12g activated carbon bags thickness of activated carbon ~ 1.5cm) were put into the container containing uranium ore, and then taken out after radon adsorption for 30 min and 85 min. After continuous measurement, the change curve of total Y number of activated carbon over time could be obtained.
pellet based activated carbon
According to the adsorption duration used in the experiment and the appropriate value of n (in the calculation process, when the adsorption duration is 30 min, n=480So it is widely used in the world sewage and waste gas treatment, air purification, recovery of rare metals and solvents and other environmental protection and resource recovery and other fields.Activated carbon is divided into granular activated carbon, powder activated carbon and activated carbon fiber, but because the powder activated carbon has secondary pollution and cannot be regenerated and activated, it is limited to use GAC-granular activated carbon (granular activated carbon)85%~90% of GAC is used for water treatment and gas adsorption treatment, and its particle size is 500~ 5000U m. The pore structure of GAC is generally a tridisperse pore distribution, which has been obtained according to the International Society of Pure and Applied Chemistry(IUPAC) Classification Aperture >Large pores at 50nm, intermediate pores at 2.0~50nm and lthttps://www.granular-activated-carbon.com