Under these conditions, the COD removal rate reached 78.6%, the BOD /COD value increased from 0.168 to 0.353-0.403, and the biodegradability was greatly improved.
If Ho is added in three times and the interval time is 10min, the COD removal rate will increase from 78.6% to 80.3%. Therefore, it can be seen that H0: batch addition will further improve the reaction effect.activated carbon suppliers in uae
After Fenton oxidation treatment, wastewater and activated carbon adsorption, this topic activated carbon adsorption experiments using single factor method, examines different PH, activated carbon adsorption dosing quantity and the influence of adsorption time of wastewater COD removal rate, the results show that after Fenton oxidation treatment without having to adjust PH value, according to the 20 g/L after adding the activated carbon reaction 3 h at room temperature, COD removal rate was 47.3%,, BOD/COD value of 0.438 to 0.625.
The research in this paper has laid a theoretical foundation and provided an experimental basis for the practical application of Fenton oxidation and activated carbon adsorption in the pretreatment of natural gas purification maintenance wastewater in UASB reactor.

In domestic has been eliminated. Specific surface area test unified the multi-point BET method at home and abroad, specific surface area measurement standards are developed at home and abroad is based on BET test method, please see our national standard (GB/T 19587-2004) - gas adsorption BET principle of solid material specific surface area measurement methods. Specific surface area testing is actually the more time-consuming jobs, as the adsorption capacity of sample is different, some sample testing may need to spend the whole dayTime, if the test process is not fully automated, the tester can not leave at any time, and should be highly focused, observe the dashboard, control the knob, a little careless will lead to the failure of the test process, which will waste a lot of valuable time of the tester.
F - Sorb 2400 specific surface tester is really able to BET method detection instruments (both direct comparison method), the more important F - Sorb 2400 specific surface tester is by far the only specific surface area of the fully automated intelligent testing equipment, the test results with the international high consistency, the stability is very good also, at the same time reduce the human error, improve accuracy test results.
dxdcarbon carbon