Principle of activated carbon adsorption
activated carbon is a kind of very small granular has a large surface area, and more tiny holes in the granular - capillary. The capillary has very strong adsorption capacity, due to the granular surface area is large, so a good contact with with gas (impurities). When these gases (impurities) encounter capillary by adsorption, purification effect. Activated carbon surface area of the study is very important, only the BET specific surface area detecting data of active carbon method detected result is reliable, domestic at present there are many instruments can only make direct comparison method of detection,
In domestic has been eliminated. Specific surface area test unified the multi-point BET method at home and abroad, specific surface area measurement standards are developed at home and abroad is based on BET test method, please see our national standard (GB/T 19587-2004) - gas adsorption BET principle of solid material specific surface area measurement methods. Specific surface area testing is actually the more time-consuming jobs, as the adsorption capacity of sample is different, some sample testing may need to spend the whole dayTime, if the test process is not fully automated, the tester can not leave at any time, and should be highly focused, observe the dashboard, control the knob, a little careless will lead to the failure of the test process, which will waste a lot of valuable time of the tester.
F - Sorb 2400 specific surface tester is really able to BET method detection instruments (both direct comparison method), the more important F - Sorb 2400 specific surface tester is by far the only specific surface area of the fully automated intelligent testing equipment, the test results with the international high consistency, the stability is very good also, at the same time reduce the human error, improve accuracy test results.
The maintenance sewage contains a large number of complex biodegradable substances, biodegradability is poor, for many years mainly rely on fresh water dilution treatment and combustion furnace treatment, but these two methods are low efficiency and high cost, so it is necessary to develop new wastewater treatment methods.
Although we have studied the upflow anaerobic sludge bed reactor (UASB) for the treatment of high concentration sewage of the natural gas purification plant, the start-up test results of 133 days show that the effluent COD removal rate is only about 40% when the influent COD is 6000mg/L, and the treatment effect is not good.dxdcarbon carbon
Therefore, it is of practical significance to explore and seek an effective pretreatment method.
In this paper, Fenton oxidation and activated carbon adsorption were combined to pretreat the wastewater from natural gas purification maintenance, in order to improve the subsequent operation efficiency of UASB.
This experiment by orthogonal test to determine the Fenton reagent oxidation first preliminary operating conditions, on this basis, carries on the single factor analysis method, the main factors influencing the Fenton reagent treatment effect for each study, investigation of its influence on wastewater COD removal rate, the results show that Fenton oxidation method the optimum operating conditions for natural gas purification overhaul wastewater treatment: HO2 dosing quantity 0.3 mol/L, n (HO)/n (Fe) = systematically, initial pH = 3, reaction temperature 70 ℃, reaction time, 40 min.activated carbon suppliers in uae
Under these conditions, the COD removal rate reached 78.6%, the BOD /COD value increased from 0.168 to 0.353-0.403, and the biodegradability was greatly improved.
If Ho is added in three times and the interval time is 10min, the COD removal rate will increase from 78.6% to 80.3%. Therefore, it can be seen that H0: batch addition will further improve the reaction effect.