Air velocity of empty tower :U= 1.0m /s.OriginalIts adsorption performance mainly depends on several main materFactors such as [10. For honeycomb activated carbon, the wall thickness is a very important parameter, by changing the wall thickness to improve its adsorption efficiency. Under the same porosity, thickness increases, the honeycomb carbon content per unit volume also will increase, which can improve the adsorption capacity. This is because the wall thickness increases, the fluid channel in the cellular cross-sectional area reduced, so the real surface or volume flow rate will increase. At the same time, the contact between adsorbate and carbon efficiency will, there is a balance between the two. Under the given conditions, the balance will determine adsorption increase or decrease. If the adsorbate at higher the diffusion rate diffuses to the inside of the honeycomb wall, and the empty adsorption site can be continuously adsorbed, so the thick-walled honeycomb should have better adsorption efficiency and adsorption capacity"Determination of air velocity and cross-sectional area of empty towerThe empty tower gas velocity is the velocity of gas passing through the entire cross section of the adsorber.The selection of air velocity not only directly determines the size and pressure drop of the adsorber, but also affects the adsorption efficiency.parameters and process parameters on it [8. Material parameters including carbon adsorption porosity, thickness of honeycomb structure and the content of carbon; process parameters including fluid flow rate and concentration of the adsorption properties of adsorption, can adsorption depends on the carbon structure and adsorption properties of features such as molecular weight). The curve is one of the main performance characterization of adsorption, adsorption is the adsorbate concentration ratio before and after the change over time of a function [9 '. This ratio is 0.95, the amount of adsorption properties of adsorption is called penetration capacity. Penetration capacity depending on the fluid flow rate, the concentration of the adsorbate and honeycomb carbon component contentNow at home and abroad the main research work is mainly the following aspects: a, additive in the functional mechanism of manufacturing activated carbon energy gao jun of China university of mining mechanism of additives in the manufacturing activated carbon made detail [4, pointed out that: the catalyst in the carbonization stage prompted carbon the destruction of the molecular structure of aromatic raw materials, to "structure" of disordering, provides a good initial activation reaction conditions, is an important factor to improve the activation of activated carbon pore. In the process of activation, potassium to strengthen the directionality of the pore, thereby reducing the unnecessary on ignition, and accelerated the process of pore forming,
And pore distribution is given priority to with microporous activated carbon; refractory in the catalyst to ash content of SiO2 and Al, 03, etc, into acid soluble potassium nepheline chemical compounds such as magnesium and calcium silicon stone is the key to improve pickling deliming rate factor b and additives on the activated carbon adsorption properties, pore structure and pore size distribution - adding different additives. The influence of the activated carbon: c, chemicals for coking products.